Manual cherokee cbs 500

Remove the top cover and look at the circuit board on the back of iomega cd designer manual the faceplate.
The CBS-500 was the cause of one such event in manual for afl live premiership edition my life.
1-remove top cover, once the channel modification has been done press (you may need to hold it down) channel 9-19 button and then turn on the radio.
The radio had vickers hydraulic training manual a "low" button to reduce the output power for local talking.Mode: AM, frequency generation: PLL, power output: 4 W, sensitivity: N/A, selectivity: N/A, image rejection: N/A.This radio had a lot of potential, especially with some of the scan and memory features.The radio has a plug in the back so you can run it on DC and it had an external speaker jack as well ( the stock internal speaker isn't anything to brag about).Manufactured: 19xx-19xx, other: Related documents: Cherokee CM-10, type: Citizen band transceiver, frequency range:.965-27.405 MHz, channels:.There are certain times in your life when you experience regret and frustration simultaneously.So they complained to Cherokee and then the manufacturer had to make it a little harder to convert.The LCD display and backlight were good and it was easy to read.Manufactured: 19xx-19xx Other: Related documents: Cherokee CBS-500 Type: Citizen band transceiver Frequency range:.965-27.405 MHz Channels: 40 Mode: AM Frequency generation: PLL Power output: 4 W Sensitivity: N/A Selectivity: N/A Image rejection: N/A Voltage:.8 VDC or mains Current drain: RX: Max?The receive was a little noisy but bearable, although it really seemed to like to pick up static more than other stations.It has a very nice and simple layout with easy to reach knobs and dual function buttons in addition to a signal/power meter and a LCD digital display showing both the channel and the frequency in 5 digit form.
I especially like the dual watch feature which allowed you two monitor two channels for activity.
Remove the top cover.
I really liked the options it provided and it seemed like a fairly well built unit.Alas, my radio was never to experience the full frequency coverage possible (which was one of the most desirable reasons to own this radio).The stock microphone is crap of course.Now the cool things - it had a channel scan which would scan through all 40 channels monitoring each one for 5 seconds.After this mod use the number 1 button to select different bands of 40 channels.Move this jumper off of the pins that it's on and put it on the side.I didn't want to damage the radio so there was a limit where I stopped myself (shortly before getting out my hammer and chisel).It was downright quiet.The radio I had bought was one of these later models and had the impenetrable substance all over the board.Now I've seen a lot of different types of plastic, rubber and glue, but whatever they used on this thing stumped me like nothing else.Having the different features show up on the LCD when activated was also very cool.Mode: AM, frequency generation: PLL, power output: 4 W, sensitivity: N/A, selectivity: N/A, image rejection: N/A Voltage:.8 VDC Current drain: RX: Max?If you must have a scan function or you like the dual watch feature than it is one of the few radios offering up those kind of things, but the real job of any radio in the end is to be able to talk.